Basic Knowledge of Antennas (2)

This article continues from "Basic Knowledge of Antennas (1)".

See more    →

HART Physical Layer Test (2)

"HART Physical Layer Test (1)" describes the first three items: HART waveform test, carrier start/stop and delay time test, and HART signal instantaneous start and stop test.This article goes on to talk about the last six items: output sound test at rest, analog change rate test, input imp

See more    →

NCS-TT106H Temperature Transmitter Calibration Specifications

Temperature transmitter is used to continuously measure resistance and millivolt voltage signals and convert them into temperature values. NCS-TT106H HART protocol temperature transmitter converts the temperature value into a 4~20mA analog current signal output that is superimposed on the HART digit

See more    →

How to Choose a Pressure Transmitter at an Intrinsically Safe Explosion-proof Site

In the chemical production process, a considerable number of applications require instruments with explosion-proof functions to meet on-site production safety requirements. Microcyber's pressure transmitter has obtained intrinsic safety and explosion-proof certification and can be used in explos

See more    →

Basic knowledge of antennas (1)

As an important component for the radiation and reception of wireless signals, antennas play a key role in wireless communications. How exactly does the antenna convert the signal from wired to wireless? What are the key parameters of an antenna, and how to evaluate the performance of an antenna? Th

See more    →

Special Applications for Dual-channel Temperature Transmitters

At various types of industrial production sites, temperature measurement points are most widely distributed. Important and key measurement points will use two temperature transmitters each connected to a single sensor or one temperature transmitter connected to two sensors, in order to achieve the p

See more    →

MC0312 Modbus to HART-IP embedded core module (Over APL)

MC0312 Ethernet-APL embedded core module is a miniaturized module developed by Microcyberthat complies with 10BASE-T1L (IEEE 802.3cg) standard. It supports bus power supply, communication rate of 10Mbps, and maximum communication distance of 1000 meters.The MC0312 Ethernet-APL embedded c

See more    →

The 32th Miconex

Microcyber will participate in MICONEX, the international measurement, control and instrumentation exhibition, held at the Century City New International Convention and Exhibition Center in Chengdu, China, from July 31 to August 2, 2024.Exhibition time: 2024/07/31~2024/08/02Exhibition location

See more    →

Introduction to Wireless Industrial Communication Technology

Industrial wireless has huge development potentialLatest research from HSM Networks shows that the industrial networking market continues to expand, with growth expected to grow 7% in 2024. It's worth noting that wireless technology has grown steadily in recent years, although the rate of growth

See more    →

Configuration and Use of MC0313 Module (3)

This article continues from "Configuration and Usage of MC0313 Module (1)" and "Configuration and Usage of MC0313 Module (2)"

See more    →

A1110 Adapter Functions and Applications

The A1110 WirelessHART adapter is an intelligent wireless interface module that can connect HART and 4-20mA field devices to the WirelessHART network without additional work and coexists with existing systems without affecting each other. The A1110 adapter sends measurement data and diagnostic infor

See more    →

HART Physical Layer Test

HART communication communicates in a half-duplex communication mode through carrier transmission. HART communication is based on the Bell202 communication standard and uses the FSK frequency shift keying signal to superimpose a digital signal with an amplitude of 0.5mA on the low-frequency 4~20mA an

See more    →